Well Pumping Plants 30 and 31
Client:
Indian Wells Valley Water District
LeRoy O. Tucker,
Assistant General Manager
(760) 375-5089		Construction Cost Information:
Original Contract:            $664,900
Contract Change Orders:  $7,500
Change Order Percentage:   1.1%
Final Construction Cost:   $672,400
One man can open the pump enclosure for easy maintenance
The project consisted of the construction of two wells and two well pumping plants. Each of the wells is approximately 1,200 feet deep and has a 16" diameter casing. The well pumping plants, which produce about 1,200 GPM and are equipped with a 200 HP pumping unit. As shown in the photographs, the pumping plants are housed in two-piece steel structures which roll open to allow ready access to the pumping units for maintenance, including removal of the entire pumping unit (motor, column, shaft, and pump bowls).
 
a good illustration of trench shoring Krieger & Stewart
Provided the following services:

PRELIMINARY SERVICES
    Site Selection/Acquisition
    Environmental Assessment/
    CEQA Compliance
    Project Financing
    Equipment Selection

DESIGN ENGINEERING
    Surveying
    Facility and Site Design
    Well Design (i.e. Gravel Pack and Well Screen)
    Structural, Mechanical,
    and Electrical Engineering
    Contract Document Preparation
    Bidding Phase Support

CONSTRUCTION ENGINEERING
    Contract Administration
    Submittals Review
    Construction Surveying and Observation
    Formation Sampling
    Acceptance (Final) Inspection

© 1997 Krieger & Stewart, Incorporated